Bruns, Terry R; Lavoie, Dawn (1994): (Table 1) Summary of basalt unit thickness, vesicularity, number of flow units, and average porosity at ODP Site 135-839 [dataset]. PANGAEA, https://doi.org/10.1594/PANGAEA.803525, Supplement to: Bruns, TR; Lavoie, D (1994): Bulk permeability of young backarc basalt in the Lau Basin from a downhole packer experiment (Hole 839B). In: Hawkins, J; Parson, L; Allan, J; et al. (eds.), Proceedings of the Ocean Drilling Program, Scientific Results, College Station, TX (Ocean Drilling Program), 135, 805-816, https://doi.org/10.2973/odp.proc.sr.135.150.1994
Always quote citation above when using data! You can download the citation in several formats below.
Abstract:
An inflatable drill-string packer was used at Site 839 to measure the bulk in-situ permeability within basalts cored in Hole 839B. The packer was inflated at two depths, 398.2 and 326.9 mbsf; all on-board information indicated that the packer mechanically closed off the borehole, although apparently the packer hydraulically sealed the borehole only at 398.2 mbsf. Two pulse tests were run at each depth, two constant-rate injection tests were run at the first set, and four were run at the second. Of these, only the constant-rate injection tests at the first set yielded a permeability, calculated as ranging from 1 to 5 * 10**-12 m**2. Pulse tests and constant-rate injection tests for the second set did not yield valid data. The measured permeability is an upper limit; if the packer leaked during the experiments, the basalt would be less permeable. In comparison, permeabilities measured at other Deep Sea Drilling Project and Ocean Drilling Program sites in pillow basalts and flows similar to those measured in Hole 839B are mainly about 10**-13 to 10**-14 m**2. Thus, if our results are valid, the basalts at Site 839 are more permeable than ocean-floor basalts investigated elsewhere.
Based on other supporting evidence, we consider these results to be a valid measure of the permeability of the basalts. Temperature data and the geochemical and geotechnical properties of the drilled sediments all indicate that the site is strongly affected by fluid flow. The heat flow is very much less than expected in young oceanic basalts, probably a result of rapid fluid circulation through the crust. The geochemistry of pore fluids is similar to that of seawater, indicating seawater flow through the sediments, and sediments are uniformly underconsolidated for their burial depth, again indicating probable fluid flow. The basalts are highly vesicular. However, the vesicularity can only account for part of the average porosity measured on the neutron porosity well log; the remainder of the measured porosity is likely present as voids and fractures within and between thin-bedded basalts. Core samples, together with porosity, density, and resistivity well-log data show locations where the basalt section is thin bedded and probably has from 15% to 35% void and fracture porosity. Thus, the measured permeability seems reasonable with respect to the high measured porosity. Much of the fluid flow at Site 839 could be directed through highly porous and permeable zones within and between the basalt flows and in the sediment layer just above the basalt. Thus, the permeability measurements give an indication of where and how fluid flow may occur within the oceanic crust of the Lau Basin.
Project(s):
Ocean Drilling Program (ODP)
Coverage:
Latitude: -20.709000 * Longitude: -176.775000
Date/Time Start: 1991-01-15T00:00:00 * Date/Time End: 1991-01-24T00:00:00
Minimum DEPTH, sediment/rock: 235.480 m * Maximum DEPTH, sediment/rock: 430.095 m
Event(s):
135-839 * Latitude: -20.709000 * Longitude: -176.775000 * Date/Time Start: 1991-01-15T00:00:00 * Date/Time End: 1991-01-24T00:00:00 * Elevation: -2629.0 m * Penetration: 735.4 m * Recovery: 123.9 m * Location: South Pacific Ocean * Campaign: Leg135 * Basis: Joides Resolution * Method/Device: Composite Core (COMPCORE) * Comment: 67 cores; 574.8 m cored; 0 m drilled; 21.6% recovery
Parameter(s):
| # | Name | Short Name | Unit | Principal Investigator | Method/Device | Comment |
|---|---|---|---|---|---|---|
| 1 | DEPTH, sediment/rock | Depth sed | m | Geocode – mbsf | ||
| 2 | Depth, top/min | Depth top | m | Bruns, Terry R | ||
| 3 | Depth, bottom/max | Depth bot | m | Bruns, Terry R | ||
| 4 | Lithologic unit/sequence | Unit | Bruns, Terry R | |||
| 5 | Thickness | Thick | m | Bruns, Terry R | ||
| 6 | Vesicularity | Vesicularity | % | Bruns, Terry R | minimum | |
| 7 | Vesicularity | Vesicularity | % | Bruns, Terry R | maximum | |
| 8 | - | - | Bruns, Terry R | flow units [contacts/m], minimum | ||
| 9 | - | - | Bruns, Terry R | flow units [contacts/m], maximum | ||
| 10 | Porosity | Poros | % vol | Bruns, Terry R | average porosity | |
| 11 | Porosity | Poros | % vol | Bruns, Terry R | possible fracture or void porrosity, minimum | |
| 12 | Porosity | Poros | % vol | Bruns, Terry R | possible fracture or void porrosity, minimum |
License:
Creative Commons Attribution 3.0 Unported (CC-BY-3.0)
Size:
78 data points