Skip to main content

Thank you for visiting nature.com. You are using a browser version with limited support for CSS. To obtain the best experience, we recommend you use a more up to date browser (or turn off compatibility mode in Internet Explorer). In the meantime, to ensure continued support, we are displaying the site without styles and JavaScript.

  • Letter
  • Published:

Low strength of deep San Andreas fault gouge from SAFOD core

Subjects

Abstract

The San Andreas fault accommodates 28–34 mm yr−1 of right lateral motion of the Pacific crustal plate northwestward past the North American plate. In California, the fault is composed of two distinct locked segments that have produced great earthquakes in historical times, separated by a 150-km-long creeping zone. The San Andreas Fault Observatory at Depth (SAFOD) is a scientific borehole located northwest of Parkfield, California, near the southern end of the creeping zone. Core was recovered from across the actively deforming San Andreas fault at a vertical depth of 2.7 km (ref. 1). Here we report laboratory strength measurements of these fault core materials at in situ conditions, demonstrating that at this locality and this depth the San Andreas fault is profoundly weak (coefficient of friction, 0.15) owing to the presence of the smectite clay mineral saponite, which is one of the weakest phyllosilicates known. This Mg-rich clay is the low-temperature product of metasomatic reactions between the quartzofeldspathic wall rocks and serpentinite blocks in the fault2,3. These findings provide strong evidence that deformation of the mechanically unusual creeping portions of the San Andreas fault system is controlled by the presence of weak minerals rather than by high fluid pressure or other proposed mechanisms1. The combination of these measurements of fault core strength with borehole observations1,4,5 yields a self-consistent picture of the stress state of the San Andreas fault at the SAFOD site, in which the fault is intrinsically weak in an otherwise strong crust.

This is a preview of subscription content, access via your institution

Access options

Rent or buy this article

Prices vary by article type

from$1.95

to$39.95

Prices may be subject to local taxes which are calculated during checkout

Figure 1: Location and strengths of SAFOD core samples.
Figure 2: Four representative deformation tests of core material from Hole G, with saponite for comparison.
Figure 3: Stress state for SAFOD drill site at 2.7 km depth.

Similar content being viewed by others

References

  1. Zoback, M., Hickman, S. & Ellsworth, W. Scientific drilling into the San Andreas Fault zone. Eos 91, 197–199 (2010)

    Article  ADS  Google Scholar 

  2. Moore, D. E. & Rymer, M. J. Talc-bearing serpentinite, and the creeping section of the San Andreas fault. Nature 448, 795–797 (2007)

    Article  ADS  CAS  Google Scholar 

  3. Moore, D. E. & Rymer, M. J. Metasomatic origin of fault gouge comprising the two creeping strands at SAFOD. Eos (Fall suppl.), paper T41A-2105. (2010)

  4. Boness, N. & Zoback, M. D. A multi-scale study of the mechanisms controlling shear velocity anisotropy in the San Andreas Fault Observatory at Depth. Geophysics 71, F131–F146 (2006)

    Article  Google Scholar 

  5. Hickman, S. & Zoback, M. D. Stress measurements in the SAFOD pilot hole: implications for the frictional strength of the San Andreas fault. Geophys. Res. Lett. 31 L15S12 10.1029/2004GL020043 (2004)

    Article  Google Scholar 

  6. Zoback, M. D., Hickman, S. & Ellsworth, W. in Treatise on Geophysics Vol. 4 (ed. Schubert, G.) 649–674 (Elsevier, 2007)

    Book  Google Scholar 

  7. Tobin, H., Ito, H., Behrmann, J., Hickman, S. H. & Kimura, G. in Report from IODP/ICDP Workshop on Fault Zone Drilling, Scientific Drilling (eds Ito, H. et al.) 5–16 (Special Issue No. 1, Integrated Ocean Drilling Program, Hokkaido, 2007)

    Google Scholar 

  8. Solum, J. G. et al. Mineralogical characterization of protolith and fault rocks from the SAFOD main hole. Geophys. Res. Lett. 33 L21314 10.1029/2006GL027285 (2006)

    Article  ADS  Google Scholar 

  9. Tembe, S. et al. Frictional strength of cuttings and core from SAFOD drillhole phases 1 and 2. Geophys. Res. Lett. 33 L23307 10.1029/2006GL027626 (2006)

    Article  ADS  Google Scholar 

  10. Holdsworth, R. E. et al. Fault rocks from the SAFOD core samples: implications for weakening at shallow depths along the San Andreas Fault, California. J. Struct. Geol. 33, 132–134 (2011)

    Article  ADS  Google Scholar 

  11. Moore, D. E. & Lockner, D. A. Frictional strengths of talc-serpentinite and talc-quartz mixtures. J. Geophys. Res. 116 B01403 10.1029/2010JB007881 (2011)

    Article  ADS  CAS  Google Scholar 

  12. Crawford, B. R., Faulkner, D. R. & Rutter, E. H. Strength, porosity, and permeability development during hydrostatic and shear loading of synthetic quartz-clay fault gouge. J. Geophys. Res. 113 B03207 10.1029/2006JB004634 (2008)

    Article  ADS  Google Scholar 

  13. Tembe, S., Lockner, D. A. & Wong, T.-f. Effect of clay content and mineralogy on frictional sliding behavior of simulated gouges: binary and ternary mixtures of quartz, illite and montmorillonite. J. Geophys. Res. 115 B03416 10.1029/2009JB006383 (2010)

    Article  ADS  CAS  Google Scholar 

  14. Collettini, C., Niemeijer, A., Viti, C. & Marone, C. Fault zone fabric and fault weakness. Nature 462, 907–910 (2009)

    Article  ADS  CAS  Google Scholar 

  15. Dieterich, J. H. Modeling of rock friction 1. Experimental results and constitutive equations. J. Geophys. Res. 84, 2161–2168 (1979)

    Article  ADS  Google Scholar 

  16. Moore, D. E., Lockner, D. A., Ma, S., Summers, R. & Byerlee, J. D. Strengths of serpentinite gouges at elevated temperatures. J. Geophys. Res. 102, 14787–14801 (1997)

    Article  ADS  CAS  Google Scholar 

  17. Moore, D. E., Lockner, D. A., Tanaka, H. & Iwata, K. The coefficient of friction of chrysotile gouge at seismogenic depths. Int. Geol. Rev. 46, 385–398 (2004)

    Article  Google Scholar 

  18. Hickman, S. H. Stress in the lithosphere and the strength of active faults. Rev. Geophys. 29, 759–775 (1991)

    ADS  Google Scholar 

  19. Brune, J. N., Henyey, T. L. & Roy, R. F. Heat flow, stress, and rate of slip along the San Andreas fault, California. J. Geophys. Res. 74, 3821–3827 (1969)

    Article  ADS  Google Scholar 

  20. Lachenbruch, A. H. & Sass, J. H. Heat flow and energetics of the San Andreas fault zone. J. Geophys. Res. 85, 6185–6222 (1980)

    Article  ADS  Google Scholar 

  21. Scholz, C. H. Evidence for a strong San Andreas fault. Geology 28, 163–166 (2000)

    Article  ADS  Google Scholar 

  22. Zoback, M. D. Strength of the San Andreas. Nature 405, 31–32 (2000)

    Article  CAS  Google Scholar 

  23. Saffer, D. M., Bekins, B. A. & Hickman, S. Topographically driven groundwater flow and the San Andreas heat flow paradox revisited. J. Geophys. Res. 108 2274 10.1029/2002JB001849 (2003)

    Article  ADS  Google Scholar 

  24. Lachenbruch, A. H. & Sass, J. H. Heat flow from Cajon Pass, fault strength, and tectonic implications. J. Geophys. Res. 97, 4995–5015 (1992)

    Article  ADS  Google Scholar 

  25. Zoback, M. D. et al. New evidence on the state of stress of the San Andreas fault system. Science 238, 1105–1111 (1987)

    Article  ADS  CAS  Google Scholar 

  26. Inoue, A. & Utada, M. Smectite-to-chlorite transformation in thermally metamorphosed volcanoclastic rocks in the Kamikita area, northern Honshu, Japan. Am. Mineral. 76, 628–640 (1991)

    CAS  Google Scholar 

  27. Rice, J. R. in Fault Mechanics and Transport Properties of Rocks (eds Evans, B. & Wong, T.-f.) 475–503 (Academic, 1992)

    Google Scholar 

  28. Tembe, S., Lockner, D. & Wong, T.-f. Constraints on the stress state of the San Andreas fault with analysis based on core and cuttings from San Andreas Observatory at Depth (SAFOD) drilling phases 1 and 2. J. Geophys. Res. 114 B11401 10.1029/2008JB005883 (2009)

    Article  ADS  Google Scholar 

Download references

Acknowledgements

We thank B. Weymer, J. Firth and P. Nelson for their assistance and patience in providing the core material. Comments from W. Ellsworth, D. Faulkner and R. Simpson significantly improved the manuscript.

Author information

Authors and Affiliations

Authors

Contributions

C.M. and D.A.L. conducted deformation experiments, D.M. provided petrographic analysis and XRD measurements, and S.H. provided borehole logging results and related stress analysis.

Corresponding author

Correspondence to David A. Lockner.

Ethics declarations

Competing interests

The authors declare no competing financial interests.

Supplementary information

Supplementary Information

This file contains Supplementary Text and Supplementary Figures 1-3 with legends. (PDF 871 kb)

PowerPoint slides

Rights and permissions

Reprints and permissions

About this article

Cite this article

Lockner, D., Morrow, C., Moore, D. et al. Low strength of deep San Andreas fault gouge from SAFOD core. Nature 472, 82–85 (2011). https://doi.org/10.1038/nature09927

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1038/nature09927

This article is cited by

Comments

By submitting a comment you agree to abide by our Terms and Community Guidelines. If you find something abusive or that does not comply with our terms or guidelines please flag it as inappropriate.

Search

Quick links

Nature Briefing

Sign up for the Nature Briefing newsletter — what matters in science, free to your inbox daily.

Get the most important science stories of the day, free in your inbox. Sign up for Nature Briefing